City of Firwood – Wizard Tower

STL Miniatures – City of Firwood – Wizard House. One of several fantastically created buildings that are a pleasure to print. No supports needed for real. Only problem with these early models are the doors, The door relies on a small printed pin to pivot on, mine broke several days after painting. To remedy this, I edited the file to have a 2mm hole through the door vertically, and then used my pin vise to drill a hole on the bottom. Amazon sells 2mm steel rods. I simply cut one to length and fixed my doors to the new rod. The tower is very tall and I have broken parts from them falling. I have gone through each layer, drilled holes and installed magnets. Total Print Information: 131hrs 15min (1126 grams of Filament)

https://www.myminifactory.com/object/3d-print-city-of-firwood-wizard-tower-233805

123 Replies to “City of Firwood – Wizard Tower”

  1. Pingback: porno izle
  2. Pingback: porn
  3. Pingback: child porn
  4. Pingback: porn
  5. Pingback: porno izle
  6. Pingback: allopurinol prices
  7. Pingback: acheter actos
  8. Pingback: porn
  9. Pingback: webmd tamsulosin
  10. Pingback: tizanidine hcl 4mg
  11. Pingback: grandpashabet
  12. Pingback: child porn
  13. Pingback: child porn
  14. Pingback: child porn
  15. Pingback: aciclovir pharmacy
  16. Pingback: order sildenafil
  17. Pingback: sex historie
  18. Pingback: cheap tadalafil uk
  19. Pingback: stromectol prices
  20. Pingback: child porn
  21. Pingback: pct nolvadex
  22. Pingback: cipro.co.za
  23. Pingback: anal porno
  24. Pingback: fuck
  25. Pingback: sikiş
  26. Pingback: community pharmacy
  27. Pingback: starzbet
  28. Pingback: starzbet
  29. Pingback: farmacias direct
  30. Pingback: farmacias direct
  31. Pingback: prednisone price
  32. Pingback: пинап кз
  33. Pingback: porno
  34. Pingback: Konya Seo Uzmanı
  35. Pingback: football skills

Comments are closed.