STL Miniatures – City of Firwood – Wizard House. One of several fantastically created buildings that are a pleasure to print. No supports needed for real. Only problem with these early models are the doors, The door relies on a small printed pin to pivot on, mine broke several days after painting. To remedy this, I edited the file to have a 2mm hole through the door vertically, and then used my pin vise to drill a hole on the bottom. Amazon sells 2mm steel rods. I simply cut one to length and fixed my doors to the new rod. The tower is very tall and I have broken parts from them falling. I have gone through each layer, drilled holes and installed magnets. Total Print Information: 131hrs 15min (1126 grams of Filament)
https://www.myminifactory.com/object/3d-print-city-of-firwood-wizard-tower-233805
332 Replies to “City of Firwood – Wizard Tower”
Comments are closed.